1. Before construction, the flatness and inclination of the site foundation shall be measured, and the construction shall be carried out after they are qualified.
2. Setting out: locate and set out according to the center point of the site and the center of two semicircles, determine the orientation of each functional point and line, and pop it up with ink lines or paint lines.
3. The artificial lawn moving into the site shall be spread along a side line to ensure that the lawn is consistent with the auxiliary line. In the process of spreading the lawn, try to keep the grass surface flat;
4. Cut the white thread grass and put it aside for use;
5. Cut the 2-3 cm edge of the artificial lawn seam with a push knife
6. Spread the joint cloth with a width of 20 or 30cm along the joint of the artificial lawn and put it under the lawn, then apply the glue evenly on the joint cloth, then splice the lawn at both ends and beat it with a rubber hammer. If the gap at the splice is large after straightening, it can be cut every 2-5cm here and stretched towards the interface to ensure a beautiful appearance;
7. After the artificial lawn is spliced, pull the wire again to determine the exact position of each functional line and point, cut the lawn with a paper cutter, put the joint belt in, scrape and apply glue, and put back the white grass line that was originally prepared. After the glue is dried, use a rubber hammer to repeatedly hammer to ensure tight bonding.
8. After paving and splicing, the wrinkled parts on the lawn need to be opened with a paper cutter, straightened and docked, cut the stacked parts, and then cemented;
9. After all the lawns are bonded, use a grass brush to comb the fallen lawns.
